燃?xì)獍l(fā)電機組千瓦起動和運行需要注意哪些事項呢？這不僅是為了保證機組的正常運行，更是為了讓工作人員良好使用機組。燃?xì)獍l(fā)電機組千瓦啟動和運行注意事項小編做出介紹。

What matters need to be paid attention to when starting and running gas-fired generator units? This is not only to ensure the normal operation of the unit, but also to allow staff to make good use of the unit. The precautions for kW startup and operation of gas-fired generator units are introduced.

一、燃?xì)獍l(fā)電機組千瓦啟動的注意事項

1、 Precautions for kW startup of gas generator set

1、按下“自動”按鈕，起動機組。機組自動在怠速下運轉暖機，待發動機油溫、水溫上升到45℃以上時，開始加速并達到正常運行狀態。

1. Press the "auto" button to start the unit. The unit will automatically run and warm up at idle speed. When the engine oil temperature and water temperature rise to more than 45 ℃, it will start to accelerate and reach normal operation.

2、在運行中經常觀察電氣儀表（電流表、電壓表、頻率表和功率表等）以及發動機儀表[機油壓力表（245~343KPa）、機油溫度表（≤95℃）、水溫表（≤95℃）和轉速表（額定轉速1500r/min）、排氣溫度（≤680℃）等）]的指示情況，其數值是否在正常范圍之內。

2. During operation, always observe the indications of electrical instruments (ammeter, voltmeter, frequency meter, power meter, etc.) and engine instruments [oil pressure gauge (245~343kpa), oil temperature gauge (≤ 95 ℃), water temperature gauge (≤ 95 ℃), tachometer (rated speed 1500r/min), exhaust temperature (≤ 680 ℃)], and whether their values are within the normal range.

二、燃?xì)獍l(fā)電機組千瓦運行中的注意事項

2、 Precautions in kW operation of gas-fired generator set

1、燃?xì)獍l(fā)電機組千瓦每次起動的時間不得超過5s，若一次起動失敗，可以間隔15s以后再次起動。若三次仍未成功，則應檢查原因并排除故障以后再起動。

1. The starting time of the gas generator set per kW shall not exceed 5S. If one start fails, it can be started again after an interval of 15s. If it fails three times, check the cause and eliminate the fault before starting.

2、注意發動機的冷卻水和機油的消耗狀況，應及時添加。

2. Pay attention to the consumption of engine cooling water and oil, and add them in time.

3、隨時注意各部位的過熱、振動和異響等異?，F(xiàn)象，并及時查明原因，排除故障。

3. Pay attention to abnormal phenomena such as overheating, vibration and abnormal noise at all parts at any time, and find out the causes in time to eliminate the faults.

4、注意發電機的工作狀況，如發現有過熱或不正常的火花現象，應及時停機檢查和維修。

4. Pay attention to the working condition of the generator. In case of overheating or abnormal sparks, stop the machine in time for inspection and maintenance.

5、發電機周圍環境應保持清潔，防水、油或沙塵等進入機組和發電機內部。不得用水沖刷發電機組。

5. The surrounding environment of the generator should be kept clean, and water, oil or sand and dust should enter the unit and generator. Do not flush the generator set with water.

6、嚴禁機組在儀表失靈或有其他故障時運行。

6. It is strictly forbidden to operate the unit in case of instrument failure or other faults.

要注意燃?xì)獍l(fā)電機組千瓦使用過程中應作好運行記錄，故障分析及處理記錄才能讓該設備更好的運行，更多內容的了解就來我們網站http://www.ttyule.net.cn看看吧。

It should be noted that the operation records should be made during the use of gas-fired generator units, and the fault analysis and treatment records can make the equipment operate better. For more information, please visit our website http://www.ttyule.net.cn Take a look.