燃氣發電機組排出的冷卻水和廢氣中的熱量通過熱回收裝置進行回收后，作為燃氣發生器的加溫熱源。燃氣發電機組功力不足故障原因及排除方法，介紹！

The heat in the cooling water and exhaust gas discharged from the gas generator unit is recycled by the heat recovery device and used as the heating source of the gas generator. The causes and troubleshooting methods of insufficient power of gas generator set are introduced!

一、燃氣發電機組燃氣系統故障

1、 Gas system failure of gas generator unit

1、燃氣氣壓低，供氣量不足

1. Low gas pressure and insufficient gas supply

2、燃氣質量差，有效成分低

2. Poor gas quality and low effective composition

3、燃氣道堵塞

3. Gas duct blocked

4、混合器膜片有裂縫

4. Cracks in the diaphragm of the mixer

解決方法：

resolvent:

1、提高氣壓

1. Increase air pressure

2、增大燃氣進氣量

2. Increase gas intake

3、清理、更換膜片

3. Clean and replace the diaphragm

二、燃氣發電機組進、排系統故障：比正常情況下排溫較高、煙色較差

2、 Fault of gas generator unit inlet and exhaust system: higher exhaust temperature and worse smoke color than normal

1、空氣濾清器阻塞

1. Air filter clogged

2、排氣管阻塞或接管過長、轉彎半徑太小，彎頭太多

2. The exhaust pipe is blocked or the connecting pipe is too long, the turning radius is too small, and there are too many elbows

解決方法：

resolvent:

清洗空氣濾清器芯子或清除紙質濾芯上的灰塵，必要時應更換

Clean the air cleaner core or remove the dust on the paper filter element, and replace it if necessary

清理排氣管內積碳：重裝排氣接管，彎頭不能多于三個，并有足夠大的排氣截面

Clean the carbon deposit in the exhaust pipe: reinstall the exhaust pipe, with no more than three elbows and sufficient exhaust cross-section

三、燃氣發電機組進、排氣相位變動；各檔轉速下性能變差

3、 The inlet and exhaust phases of the gas generator set change; Poor performance at various speeds

解決方法

resolvent

進行配氣相位和氣門間隙檢查

Check the valve timing and valve clearance

燃氣發電機組動力不足故障原因及排除方法，做出了介紹，希望能給用戶帶來參考。更多相關內容就來我們網站http://www.ttyule.net.cn咨詢！

The causes and troubleshooting methods of insufficient power of gas generator set are introduced in the hope of providing users with reference. Come to our website for more relevant content http://www.ttyule.net.cn consulting service